PCL or PS font list
Use the font lists to see which fonts are currently installed in the MFP. (The font lists also
show which fonts are resident on a hard disk or flash DIMM.)
The PS font list shows the PS fonts installed, and gives a sample of those fonts. The
following describes the information that can be found on the PCL font list:
●
Font gives the font names and samples.
●
Pitch/Point indicates the pitch and point size of the font.
●
Escape Sequence (a PCL 5e programming command) is used to select the designated
font. (See the legend at the bottom of the font list page.)
●
Font # is the number used to select fonts from the control panel (not the software
application). Do not confuse the font # with the font ID (see the following information).
The number indicates the DIMM slot where the font is stored.
●
Soft: Downloaded fonts that stay resident in the MFP until other fonts are
downloaded to replace them or until the MFP is turned off.
●
Internal: Fonts that permanently reside in the MFP.
●
Font ID is the number you assign to soft fonts when you download them through software.
ENWW
Checking the MFP configuration
165