Determining MFP problems
Situation/Message
Solution
The control-panel display is blank, and internal
fans are not running.
Make sure that the MFP power is on. Press all
the keys to see if one is stuck. Contact your HP-
authorized service representative if these steps
do not work. See
HP customer care
.
The MFP is turned on, but the internal fans are
not running.
Make sure that the line voltage is correct for the
MFP power configuration. (See the label that is
inside the top cover on the MFP for voltage
requirements.) If you are using a power strip and
its voltage is not within specification, plug the
MFP directly into the power receptacle.
The MFP voltage is not correct.
Make surethat the line voltage is in the correct
range. (See the label that is inside the top cover
on the MFP for voltage requirements.)
Messages appear on the control-panel display.
See
Understanding MFP messages
.
Print media is jammed in the MFP.
Check for jams (see
Clearing jams
).
The control-panel display shows the wrong
language or unfamiliar characters.
Reconfigure the control-panel display language.
1.
Turn the MFP off and then on.
2.
When XXXMB appears on the control-panel
display, press and hold
6
until all three
LEDs flash once and then stay on. (This
might take up to 20 seconds.
3.
Release
6
and then press
6
again.
4.
Wait while the MFP completes its
initialization sequence. When it is finished,
the SELECT LANGUAGE menu appears on
the control-panel display. Scroll to and touch
the correct language.
An error occurs during a Digital Send job. Job
failed.
The MFP experienced an error during the digital
sending job. The administrator should check on
the status of the SMTP server. See
Solving
e-mail problems
.
The e-mail gateway could not accept the job
because the attachment is too large.
Reduce the size of the e-mail attachment by
setting the maximum attachment size. Set the
maximum attachement size on the Digital
Sending tab of the embedded Web server. See
Using the embedded Web server
.
Try using a different file format or sending the
document a few pages at a time.
A network connection is required for digital
sending
The MFP cannot find a network connection. The
administrator should check to see if the MFP is
connected to the network. See
Solving network
connectivity problems
.
184
Chapter 10 Solving problems
ENWW