FCC Part 68 Telecom
If requested, you must be prepared to provide the telephone company with the following information for
the SocketModem card included within this product:
Manufacturer:
Multi-Tech Systems, Inc.
2205 Woodale Drive
Mounds View, MN 55112
USA
Trade Name:
Modem Module
Model Number:
MT5634SMI
FCC Registration No:
AU7-USA-25814-M5-E
Ringer Equivalence:
0.3B
Modular Jack (USOC):
RJ11C or RJ11W (single line)
Service Center in USA:
U.S.A.
(763) 785-3500
(763) 785-9874 Fax
The equipment complies with FCC Rules, Part 68. The Socket Modem Module has a label that contains,
along with other information, the FCC registration number and ringer equivalence number (REN) for this
equipment. If requested, this information must be provided to the telephone company. The REN is used
to determine the quantity of devices which may be connected to the telephone line. Excessive RENS
on the telephone line may result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENS should not exceed five (5.0). To be certain of the number of devices
that may be connected to the line, as determined by the total RENS, contact the Telephone Company
to determine the maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C or RJ11W (single line)
134 Dodatek C Regulativne informacije
SLWW
An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack
with is Part 68 compliant. This equipment cannot be used on telephone company provided coin service.
Connection to Party Line Service is subject to state tariffs. If this equipment causes harm to the telephone
network, the telephone company will notify you in advance that temporary discontinuance of service
may be required. If advance notice isn't practical, the Telephone Company will notify the customer as
soon as possible. Also you will be advised of your right to file a complaint with the FCC if you believe it
is necessary. The telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. If this happens, the telephone company
will provide advance notice in order for you to make the necessary modifications in order to maintain
uninterrupted service. If trouble is experienced with this equipment, please contact HP customer service
by using the contact information provided in the Customer Support section of this manual for
troubleshooting, repair and (or) warranty information. If the trouble is causing harm to the telephone
network, the Telephone Company may request you remove the equipment from the network until the
problem is resolved. The following repairs can be done by the customer: Replace any original equipment
that came with the product and the telephone cord. It is also recommended that the customer install an
AC surge arrestor in the AC outlet of the host equipment to which the device is connected. This is to
avoid damage to the equipment caused by lightning strikes and other electrical surges.